OSPI - UG1612

VEK280 Evaluation Board User Guide (UG1612)

Document ID
UG1612
Release Date
2024-01-31
Revision
1.1 English

This boot mode is supported onboard and is wired to the XCVE2802 U1 bank 500 PMC_MIO[0:12] pins. The octal SPI controller can access two devices using several different methods. See the Flash Memory Controllers section of the Versal Adaptive SoC Technical Reference Manual (AM011) for more information. To boot from OSPI:

  1. Store a valid XCVE2802 adaptive SoC boot image file in the OSPI.
  2. Set boot mode SW1 for OSPI as indicated in the "Mode Switch SW1 Configuration Option Settings" table in Versal Device Configuration.
  3. Power-cycle the VEK280 board or press the POR pushbutton SW2. SW2 is near the USB-C JTAG port J369 in the figure in Board Component Location.