The following table lists the default switch settings.
| Callout Number | Ref. Des. | Function | Default | Schematic Page |
|---|---|---|---|---|
| 11 | SW1 | U1 mode 4-pole DIP switch Switch OFF = 1 = high; ON = 0 = low Mode = SW1[1:4] = Mode[0:3] SD = ON,OFF,OFF,OFF = 0111 QSPI32 = ON,OFF,ON,ON = 0100 JTAG = ON,ON,ON,ON = 0000 |
ON, ON, ON, ON | 22 |
| 12 | SW2 | VPK180 power-on reset (POR_B) | Open | 23 |
| 13 | SW3 | SYSCTLR JTAG source selection Switch OFF = 1 = high; ON = 0 = low SYSCTLR JTAG SOURCE SEL = SW3[1:2] = SEL[0:1] PL JTAG = ON,ON = 00 FTDI JTAG = OFF,ON = 10 Trace Mictor38 JTAG = ON,OFF = 01 |
OFF, ON | 35 |
| 14 | SW4, SW5 | User pushbutton inputs Note: Pushbutton switch default = open = logic low (not
pressed).
|
Open | 65 |
| 15 | SW6 | User GPIO DIP Switch OFF = 0 = low; ON = 1 = high |
OFF, OFF, OFF, OFF | 65 |
| 16 | SW11 | SYSCTLR mode 4-pole DIP switch Switch OFF = 1 = high; ON = 0 = low Mode = SW1[1:4] = Mode[0:3] QSPI32 = ON,OFF,ON,ON = 0100 eMMC = ON,OFF,OFF,ON = 0110 JTAG = ON,ON,ON,ON = 0000 |
ON, OFF, ON, ON | 97 |
| 17 | SW12 | System controller power-on reset (SYSCTL_POR_B) | Open | 97 |
| 18 | SW13 | Main power | OFF | 66 |
| 19 | SW14 | User USB reset | Open | 53 |
| 20 | SW15 | User GEM reset | Open | 52 |
| 21 | SW16 | System controller FWUEN pushbutton (SYSCTLR_MIO12_FWUEN_C2M_B) See BEAM wiki for more information |
Open | 96 |