The memory-mapping of the peripherals (slaves) instantiated in the block design are automatically assigned, but you can also assign the addresses manually. Perform the following steps to generate the address map for this design.
- Click the Address Editor tab above the diagram.
- Click the Assign All
button.
Set addresses by entering values in the Offset Address and Range columns. See section Addressing for Block Designs in the Vivado Design Suite User Guide: Designing IP Subsystems using IP Integrator (UG994) for more information.
Figure 1. Memory-Mapping Peripherals
Tip: The Address Editor tab only opens if the
Diagram contains an IP. For
example, a MicroBlaze device that functions as a bus
master in the design.