SD1_3.0 - UG1568

VPK120 Evaluation Board User Guide (UG1568)
Document ID
UG1568
Release Date
2025-04-09
Revision
1.2 English

To boot from a SD card installed in microSD card socket J302, follow these steps.

  1. Store a valid XCVP1202 adaptive SoC boot image file on a microSD card. Plug the SD card into the VPK120 evaluation board SD socket J302 connected to the XCVP1202 U1 bank 501 MIO SD interface.
  2. Set boot MODE SW1 for SD1_3.0 as indicated in the table in Versal Adaptive SoC Configuration.
  3. Power-cycle the VPK120 board or press the POR pushbutton SW2. SW2 is near the mode pin dip switch in the figure in Board Component Location.