SAMTEC LPAM Host Interface Connector - SAMTEC LPAM Host Interface Connector

The CLK104 RF clock add-on card mates with RFSoC evaluation boards using a low profile, 120-pin, high-speed SAMTEC LPA connector. The following figure shows the mezzanine module connector pin-out and the table that follows identifies the pins.

Figure 1. LPA Connector Pin-out

Table 1. LPA Connector Pin Descriptions
Pin	Signal Name	Description	LMK04828 Pin
E2	DAC_REFCLK_P	DAC REFCLK, routed to RFSoC DAC on board	DCLKout6*
E3	DAC_REFCLK_N	DAC REFCLK, routed to RFSoC DAC on board	DCLKout6*
B2	ADC_REFCLK_P	ADC REFCLK, routed to RFSoC ADC on board	DCLKout12*
B3	ADC_REFCLK_N	ADC REFCLK, routed to RFSoC ADC on board	DCLKout12*
B8	AMS_SYSREF_P	AMS SYSREF, routed to RFSoC SYSREF on board	SDCLKout3*
B9	AMS_SYSREF_N	AMS SYSREF, routed to RFSoC SYSREF on board	SDCLKout3*
B15	PL_CLK_P	PL CLK, routed to PL bank on board	DCLKout8*
B16	PL_CLK_N	PL CLK, routed to PL bank on board	DCLKout8*
B12	PL_SYSREF_P	PL_SYSREF, routed to PL bank on board	SDCLKout9*
B13	PL_SYSREF_N	PL_SYSREF, routed to PL bank on board	SDCLKout9*
B18	DDR_PLY_CAP_SYNC_P	DDR Playback/Capture Sync, routed to PL bank on board	SDCLKout7*
B19	DDR_PLY_CAP_SYNC_N	DDR Playback/Capture Sync, routed to PL bank on board	SDCLKout7*
E15	SFP_REC_CLK_P	Recovered clock from RFSoC PL banks	CLKin0
E16	SFP_REC_CLK_N	Recovered clock from RFSoC PL banks	CLKin0
E9	SYNC_IN	SYNC signal routed to PL bank on board	SYNC
E18	CLK104_SCL	I2C bus SCL	--
E19	CLK104_SDA	I2C bus SDA	--
B5	CLK_SPI_MUX_SEL0	PLL SPI MUX SEL0	--
B6	CLK_SPI_MUX_SEL1	PLL SPI MUX SEL0	--

Note: The output frequency, power level, and enable/disable of each LMK04828B output are subject to change as determined by the configuration files.

SAMTEC LPAM Host Interface Connector - SAMTEC LPAM Host Interface Connector - UG1437

CLK104 RF Clock Add-on Card User Guide (UG1437)