Replacing the Bracket

Alveo U30 Data Center Accelerator Card Installation Guide (UG1425)

Document ID
Release Date
1.2.1 English
The Alveo U30 card can be used with either a full-height or half-height bracket. Depending on your system, it may be necessary to switch between the full and half-height bracket on the card. The bracket is secured to the card with four screws, as shown in the figure below. To replace the bracket, follow the instructions below.
  1. Remove screws 1 and 2 from the card.
  2. Remove screws 3 and 4 from the card.
  3. Remove the bracket from the card.
  4. Place the new bracket on the card and align it with the card's connectors and screw locations.
  5. Replace screws 1 and 2 on the new bracket.
  6. Replace screws 3 and 4 on the new bracket.
Figure 1. Screw Locations on Bracket