Parameters in XPM NoC - 2024.2 English - UG1387

Versal Adaptive SoC Hardware, IP, and Platform Development Methodology Guide (UG1387)

Document ID
UG1387
Release Date
2024-12-18
Version
2024.2 English

The NoC XPMs contain the following parameters:

NOC_FABRIC
Choosing the required NMU/NSU of the given device, available values are VNoC and BLI, default is VNoC. VNoC NoC instances are distributed throughout the NoC fabric. Boundary Logic Interface (BLI) registers are usually confined to the perimeter of the PL fabric.
DATA_WIDTH
AXI Channel Data width, allowed values are 32, 64, 128, 256, and 512. The default value is 512.
ADDR_WIDTH
AXI Channel Address Width, allowed values are from 12 to 64. The default value is 64.
ID_WIDTH
AXI Channel ID PORT width, allowed values are 1 to 16. The default value is 16.
AUSER_WIDTH
Allowed values are 16 and 18, which disables/enables parity, respectively. The default value is 16.
DST_ID_WIDTH
AXI Channel DST post width. Available only for streaming interfaces. Allowed values are 1 to 4. The default value is 4.
DUSER_WIDTH
User defined width for USER bits.
ENABLE_USR_INTERRUPT
Signal to enable/disable 4-bit interrupt.
SIDEBAND_PINS
Parameter to enable/disable AXI sideband pins. Sideband pins are low-order bits added to the AXI USER field, without affecting the contents of the USER field, that are typically used to pass parity or SMID information through the AXI network.