Verifying the Image on the ZCU102 Board - 2024.2 English - UG1209

To verify the image, follow these steps:

1. Copy the BOOT.BIN, image.ub, and boot.scr files to the SD card. Here, boot.scr is read by U-Boot to load the kernel and rootfs.

2. Load the SD card into the ZCU102 board, in the J100 connector.

3. Connect a micro USB cable from the ZCU102 board USB UART port (J83) to the USB port on the host machine.

4. Configure the board to boot in SD boot mode by setting switch SW6 as shown in the following figure.

   

5. Connect 12V power to the ZCU102 6-pin Molex connector.

6. Start a serial terminal session using Tera Term or Minicom depending on the host machine being used. set the COM port and baud rate for your system as shown in the following figure.

   

   Fig. 12 Tera Term Connection

7. For port settings, verify the COM port in the device manager and select the COM port with interface-0.

8. Turn on the ZCU102 board using SW1, and wait until Linux loads on the board.