Running the hello_system System Project on Hardware - 2024.2 English - UG1209

Set up the board as in Example Project 1:

1. Connect the power and USB cables for UART and JTAG.

2. Set the boot mode to JTAG boot mode.

3. Power on.

Connect the serial console for UART-0 and UART-1:

1. Use the MobaXterm utility to connect multiple UART ports.

2. Open USB UART Interface-0 for UART-0 for APU.

3. Open USB UART Interface-1 for UART-1 for RPU.

Run hello_system on hardware by right-clicking hello_system in the Explorer window, and selecting Run As → Launch Hardware.

The message from MobaXterm shows prints from the APU and RPU.

Fig. 9 System Project Prints on Serial window