Setting Up the Board - 2023.2 English

Zynq-7000 SoC Embedded Design Tutorial (UG1165)
Document ID
UG1165
Release Date
2024-05-02
Version
2023.2 English

  1. Connect the power cable to the board.

  2. Connect the USB UART cable to J17.

  3. Connect the USB JTAG cable:

    1. Connect a micro USB cable between the host machine and the ZC702 target board U23. .. note:: Do not to use J1. 2. Make sure that the SW10 switch settings for JTAG selection are set to choose USB JTAG:

    • Bit-1 is 0

    • Bit-2 is 1

    JTAG Select SW10

    Note

    • 0 = switch is open.

    • 1 = switch is closed.

  4. Setup JTAG boot mode using the switch indicated in the following figure.

    • Ensure that jumpers J27 and J28 are placed on the side farther from the SD card slot.

    • Change the SW16 switch setting as shown in the following figure.

    JTAG Boot Setup

    JTAG Boot Setup

  5. Power on the ZC702 board.