Booting Linux from QSPI Flash - 2023.2 English

Zynq-7000 SoC Embedded Design Tutorial (UG1165)
Document ID
UG1165
Release Date
2024-05-02
Version
2023.2 English

  1. After you program the QSPI Flash, set the SW16 switch on your board as shown in the following figure.

    ../_images/image88.jpeg

  2. Connect the serial terminal using a 115200 baud rate setting.

    Note

    This is the baud rate that the UART is programmed to on Zynq devices.

  3. Switch on the board power.

    A Linux booting message appears on the serial terminal. After booting finishes, the root@xilinx-zc702-2020_2:~# prompt appears. Enter the login and password as root when prompted.

  4. Check the board IP address connectivity as described in Booting Linux in JTAG Mode.

See the next chapter to connect the dots and create a more complicated design.