Resets - Resets - 1.0 English - PG441

MIPI DSI-2 Receiver Subsystem LogiCORE IP Product Guide (PG441)

Document_ID
PG441
Release_Date
2026-07-27
Version
1.0 English

The subsystem has two reset ports:

lite_aresetn
Active-Low reset for the AXI4-Lite register interface.
video_aresetn
Active-Low reset for the subsystem blocks.

The duration of video_aresetn should be a minimum of 40 dphy_clk_200M cycles to propagate the reset throughout the system. See the following figure.

Figure 1. MIPI DSI-2 RX Reset

The following table summarizes all resets available to the MIPI DSI-2 RX Subsystem and the components affected by them.

Table 1. Resets
Sub-core lite_aresetn video_aresetn
MIPI DSI-2 RX Controller Connected to s_axi_aresetn core port Connected to video_aresetn core port
MIPI D-PHY Connected to s_axi_aresetn core port Inverted signal connected to core_rst core port
AXI Crossbar Connected to aresetn core port N/A
Note: Minimum 10 clock cycles of clk-pre is required to flush internal FIFOs.
Note: The effect of each reset (lite_resetn, video_aresetn) is determined by the ports of the sub-cores to which they are connected. See the individual sub-core product guides for the effect of each reset signal.