PROGRAMMABLE SEQUENCE DATA1 Register (0x40) - PROGRAMMABLE SEQUENCE DATA1 Register (0x40) - 1.0 English - PG436

MIPI TX C-PHY/D-PHY LogiCORE IP Product Guide (PG436)
Document ID
PG436
Release Date
2026-06-23
Version
1.0 English

The Programmable Sequence data1 register is used to send the symbols 10 to 13 of programmable sequence. The following table provides the register bit description. This register is used in C-PHY configuration only.

Note: Programmable Sequence insertion only applies to the Normal Preamble.
Table 1. Programmable Sequence Data1 Register Bit Description
Bits Name Default Value Access type Description
31:12 Reserved 0x0 RO Reserved
11:9 prog_seq_data13 0x3 R/W S13 in the Programmable Sequence Values:
  • 0 to 4: Symbol value
  • 5 to 7: Invalid value, not a valid symbol value.
8:6 prog_seq_data12 0x3 R/W S12 in the Programmable Sequence Values:
  • 0 to 4: Symbol value
  • 5 to 7: Invalid value, not a valid symbol value.
5:3 prog_seq_data11 0x3 R/W S11 in the Programmable Sequence Values:
  • 0 to 4: Symbol value
  • 5 to 7: Invalid value, not a valid symbol value.
2:0 prog_seq_data10 0x3 R/W S10 in the Programmable Sequence Values:
  • 0 to 4: Symbol value
  • 5 to 7: Invalid value, not a valid symbol value.