Example 5: D-PHY TX Clock Lane ULPS Operation - Example 5: D-PHY TX Clock Lane ULPS Operation - 1.0 English - PG436

This section describes a TX clock lane ULPS operation.

1. The PPI drives txulpsclk to initiate the clock lane ULPS mode.
2. The MIPI TX C-PHY/D-PHY core drives the clock lane ulpsactivenot (active-Low) to Low after the ULPS entry sequence is transmitted on the serial line.
3. The PPI asserts the txulpsexit signal to exit from ULPS.
4. The MIPI TX C-PHY/D-PHY core drives the ulpsactivenot High and drives MARK-1 on the serial lines.
5. The PPI deasserts the txrequestesc after T_WAKEUP time has elapsed following deassertion of the ulpsactivenot signal.

The following figure shows the TX clock lane ULPS operation.