VEK385 Hardware Setup - VEK385 Hardware Setup - 2.0 English - PG432

1. Set up the hardware connections as shown in the following figure:
   1. Mount the Xylon FMC GMSL2 Module onto the VEK385 FMC Slot (when ISP is to be used in LILO or LIMO Mode).
      
      
   2. Connect the 3MP Sensors to Xylon FMC Channels (CH2_0 and CH4_0) using Fakra cables as shown in the following figures.
      
      
      
      
   3. Connect the HDMI cable to the VEK385HDMI port.
   4. Connect the other end of the HDMI cable to the HDMI monitor.
   5. Switch on the HDMI monitor, and select HDMI as the input source.
   6. Attach the USB-(JTAG+UART) programming cable from the host PC to the Type-C USB board port designated for JTAG and UART connections.
   7. Make sure XSDB and hw_server is running.
2. Connect the power supply cable, and turn on the VEK385 board.
3. Start a Hyper Terminal program on the host PC with following settings:

   Baud rate

   115200

   Data Bits

   9

   Parity

   None

   Stop Bits

   1

   Flow Control

   None