Figure 1. Outputs Tab
- ISP<0/1> Outputs
- When the ISP0 and ISP1 IO Type is LIMO/MIMO, this tab is
blank.
- Enable Primary Output
- Select this check box to enable the primary output from OBA. At least one of the primary and secondary outputs must be enabled in LILO Mode.
- Enable Secondary Output
- Select this check box to enable the secondary output from OBA. At least one of the primary and secondary outputs must be enabled in LILO Mode.
- Pixels Per Clock
- Select [1/2/4] pixels per clock to be streamed out by OBA on the primary/secondary output(s).
- Primary/Secondary output Configuration
- Visible when Enable Primary/Secondary Output is
selected.
- Supported data formats
- When you select the first data
format from the following supported options below, a
configuration data object (CDO) generates:
- RGB888
- Select to include the RGB888 data format in the list of supported data formats by the OBA's primary/secondary output.
- YUV422
- Select to include the YUV422 data format in the list of supported data formats by the OBA's primary/secondary output.
- YUV420
- Select to include the YUV420 data format in the list of supported data formats by the OBA's primary/secondary output. When this data format is included in the list, no other data formats (RGB888/YUV422/Y) can be included in the list of supported data formats.
- Y
- Select to include the Y-only data format in the list of supported data formats by the OBA's primary/secondary output.
- Monochrome (IR)
- Select to include the
Monochrome (IR) data format in the list of
supported data formats by the OBA's secondary
output.Note: The Monochrome (IR) data format is supported only on OBA's secondary output.
- Bits Per Component
- Select 8 or 10 bits per component for the supported data formats selected to stream out on the primary/secondary output of the OBA.