SDI Status Output Signals (sdi_gt_sts[15:0]) - SDI Status Output Signals (sdi_gt_sts[15:0]) - 4.0 English - PG398

Versal Adaptive SoC GT Controller for DisplayPort and SDI LogiCORE IP Product Guide (PG398)
Document ID
PG398
Release Date
2026-02-11
Version
4.0 English
Table 1. SDI Status Output Signals (sdi_gt_sts[15:0])
Bits Clock Domain Description
0 gt_ctrl_aclk Used in Duplex and RX only mode. If set to 1, indicates that LCPLL has been locked.
1 gt_ctrl_aclk Used in Duplex and RX only mode. If set to 1, indicates that channel 0 RX reset was synced.
2 gt_ctrl_aclk Used in Duplex and RX only mode. If set to 1, indicates that RX changes was applied.
3 gt_ctrl_aclk Used in Duplex and RX only mode. RX fabric reset.
4 gt_rxusrclk Used in Duplex and RX only mode. RX modes locked.
5 gt_rxusrclk Used in Duplex and RX only mode. If set to 1, indicates that received data is level B.
6 Reserved.
7 gt_rxusrclk Used in Duplex and RX only mode. Receiver clock enable signal.
10:8 gt_rxusrclk Used in Duplex and RX only mode. Receiver Mode information.
11 gt_ctrl_aclk Used in Duplex or TX only mode. If set to 1, indicates that RPLL has been locked.
12 gt_ctrl_aclk Used in Duplex or TX only mode. If set to 1, indicates that channel 0 TX reset done has been synced.
13 gt_ctrl_aclk Used in Duplex or TX only mode. If set to 1, indicates that TX changes is applied.
14 gt_ctrl_aclk Used in Duplex or TX only mode. Transmitter fabric reset.
15 Reserved.