| gtwiz_reset_all_in <0-5> |
I |
Multi-bit reset input to the GT Reset IPs for
Multi-Quad control. It resets the PLL and datapath of GT. |
| gt_reset_tx_datapath_in_<0-23> |
I |
TX reset datapath input to the GT Reset
IP. |
| gt_reset_rx_datapath_in_<0-23> |
I |
RX reset datapath input to the GT Reset
IP. |
| gt_tx_reset_done_out_<0-23> |
O |
TX Reset Done output from the GT Reset
IP. |
| gt_rx_reset_done_out_<0-23> |
O |
RX Reset Done output from the GT Reset
IP. |
- These ports are applicable for Legacy GT
Wizard only.
- You can control the gtwiz_reset_all_in based on the configuration and
the number of Quads individually. For example, for NRZ
configurations, each quad can be controlled by each bit of
reset input. For PAM4, each dual can be controlled by each
bit. The reset operation must be based on the configuration
selected, similar to the Assertion and Deassertion of DCMAC Resets section.
- For more information on the usage of the above mentioned GT reset
control ports, refer to the Validating the Example Design section.
|