| gtwiz_reset_all_in <0-5> |
I |
Multi-bit reset input to the GT Reset IPs for
Multi-Quad control. It resets the PLL and datapath of GT. |
| gt_reset_tx_datapath_in_<0-23> |
I |
TX reset datapath input to the GT Reset
IP. |
| gt_reset_rx_datapath_in_<0-23> |
I |
RX reset datapath input to the GT Reset
IP. |
| gt_tx_reset_done_out_<0-23> |
O |
TX Reset Done output from the GT Reset
IP. |
| gt_rx_reset_done_out_<0-23> |
O |
RX Reset Done output from the GT Reset
IP. |
- These ports are applicable for Legacy GT
Wizard only.
- You can control the gtwiz_reset_all_in based
on the configuration and the number of Quads individually.
For example, for NRZ configurations, each quad can be
controlled by each bit of reset input. For PAM4, each dual
can be controlled by each bit. The operation of reset should
be based on the configuration selected, similar to the Assertion and Deassertion of DCMAC Resets section.
- For more information on the usage of the above mentioned GT
reset control ports, see the Validating the Example Design section.
|