The clocking wizard provides a drop-down menu for each clk_out
starting from clk_out
1 to 3 for you to select DESKEW_PD1 from the PI
control column. When you select this option, 2’b01 is set to CLKOUTx_PHASE_CTRL
parameter.
When you select DPLL deskew feature, reset
and
power_down
ports are exposed automatically and these
signals must pass through a calibrated soft logic present inside the IP. Whenever the
soft logic is enabled, PERF_MODE
of the primitive is set to FULL by the
IP. Then the outputs of the calibrated logic are connected to the DPLL primitive. Clock
input connection to the DPLL must be a ref_clk
connection on the calibrated soft logic. This feature/calibration logic implementation
helps you to get the proper clock output without any glitches. Following is the
schematic with digital deskew in DPLL enabled: