Validate the Design on the VCK190/VMK180 - 2.3 English

Versal Devices Integrated 100G Multirate Ethernet MAC Subsystem Product Guide (PG314)

Document ID
PG314
Release Date
2024-05-30
Version
2.3 English
  1. Once the bitstream (.pdi) and the application file (.elf) are ready, power ON the Versal board.

    Ensure that all power UART and loopback cable connections are properly connected. Refer to the VCK190 Evaluation Board User Guide (UG1366) and VMK180 Evaluation Board User Guide (UG1411) for additional information.

  2. Before dumping the MRMAC image, configure the device with the required reference frequency, as shown in the following figure. Clock programming files can be obtained through the Versal Lounge.

  3. Launch the Vivado hardware manager. Select the Versal device and program the device.
    1. Launch the Vivado Lab Edition, and click Open Hardware Manager.
    2. Select Open Target > Open New Target > Next > Next > Finish.
    3. Right click vjtag40_1, and select Program Device as shown in the following figure.
    4. Browse to the path where the bitstream (.pdi) is located, and then select Program.
  4. Open the xsdb console in C:\Xilinx\Vivado_Lab\2021.1\bin. Follow the procedure as shown in the following snapshot and observe the results in Tera Term.





    Note: Set the .elf file path before downloading .elf.

    See the results in Tera Term.