Display User Console - 3.1 English

DisplayPort 1.4 RX Subsystem Product Guide (PG300)

Document ID
PG300
Release Date
2024-05-30
Version
3.1 English

The Pass-Through application (KCU105) checks if a monitor is connected soon after it executes. If a monitor is already connected, it starts up the following options as shown in the following figure from which to choose (KCU105).

Figure 1. DisplayPort User Console

Selecting either r or s puts the system in Pass-Through mode, where the video received by the RX is forwarded to the TX. It configures the vid_phy_controller and sets up the DisplayPort for RX. If a DisplayPort source (for example, GPU) is already connected to DisplayPort RX Subsystem, it starts the training. Otherwise, the training starts when the cable is plugged in. As soon as the training is completed, the application starts the DisplayPort TX Subsystem. The video should be seen on the monitor after the TX is up. The previous figure shows the UART transcript. The transcript might differ based on the training done by the GPU.