The reference design runs on the AMD Versal Adaptive SoC Evaluation Board (VEK385), using the SDI available on the board, as shown in the example in the following figure.
Figure 1. VEK385 Board Setup
- Connect a USB cable from the host PC to the USB JTAG port (1). Ensure the appropriate device drivers are installed.
- Insert a Fidus FMC card into FMC slot (2).
- Connect the HD-BNC of FMC Card (3) to the SDI sink device.
- Connect the HD-BNC of FMC Card (4) to the SDI source device.
- Connect the VEK385 board to a power supply slot (5).
- Switch on the VEK385 board (6).
- Ensure that the HW-VEK385 board revision is as selected in GUI interface.
- Ensure that the SMPTE ST 352/Payload ID is enabled in the SDI Stream connected to the SDI input link of VEK385.
- Start Tera Term or PuTTY to connect to the COM port interface 0 on the Host PC configured with 115200 bps, 8 bits, No parity, 1 stop bit, and no flow control.