Running the ZCU106 Pass-Through Example Design - 2.0 English

SMPTE UHD-SDI Receiver Subsystem LogiCORE IP Product Guide (PG290)
Document ID
PG290
Release Date
2024-06-19
Version
2.0 English
  1. Open the Vivado Design Suite and create a new project.
  2. In the pop-up window, press Next three times as shown in the following figure.
    Figure 1. ZCU106 Pass-Through New Project
  3. Select the ZCU106 Board as shown in the following figure.
    Figure 2. Select the ZCU106 Board
  4. Click Finish.
  5. Click IP Catalog and double-click SMPTE UHD-SDI RX Subsystem under Video Connectivity as shown in the following figure.
    Figure 3. Select the SMPTE UHD-SDI RX Subsystem
    Note: For the application example design flow, the IP configuration is based on options selected in the Application Example Design tab. You can rename the IP component name, which is used as the application example design project name.
  6. Configure the SMPTE UHD-SDI RX Subsystem Application Example Design tab by selecting ZCU106 as the Target Board followed by Audio-Video Pass-Through as Design Topology, and then click OK.

    The Generate Output Products dialog box appears.

  7. Click Generate (See the following figure).
    Note: Click Skip if you only want to generate the application example design.
    Figure 4. Generate Output Products
  8. Right-click the SMPTE UHD-SDI RX Subsystem component under Design source, and click Open IP Example Design, as shown in the following figure.
    Figure 5. Open IP Example Design
  9. Choose the target project location, then click OK.

    The IP integrator design is then generated and creates the Vitis software platform generates a .elf file. You can choose to Run Synthesis, Implementation, or Generate Bitstream. An overall system IP integrator block diagram of the ZCU106-based application example design is shown in the following figure.

    Figure 6. IP Integrator Diagram of the ZCU106 Pass-Through Example Design