Running the KCU116 Audio-Video Loopback Example Design - 2.0 English - PG290

SMPTE UHD-SDI Receiver Subsystem LogiCORE IP Product Guide (PG290)
Document ID
PG290
Release Date
2024-12-11
Version
2.0 English
  1. Open the Vivado Design Suite and create a new project.
  2. In the pop-up window, press Next five times.
  3. Select the KCU116 Board.
    Figure 1. Select the KCU116 Board
  4. Click Finish.
  5. Click IP catalog and double-click SMPTE UHD-SDI RX Subsystem under Video Connectivity, as shown in the following figure.
    Figure 2. Select the SMPTE UHD-SDI RX Subsystem
    Note: For the application example design flow, the IP configuration is based on the options selected in the Application Example Design tab. You can rename the IP component name, which is used as the application example design project name.
  6. Configure the SMPTE UHD-SDI RX Subsystem Application Example Design tab by selecting KCU116 as the Target Board followed by Audio-Video Pass-Through as the Design Topology and click OK.

    The Generate Output Products dialog box appears

  7. Click Generate.
    Note: Click Skip if you only want to generate the application example design.
    Figure 3. Generate Output Products
  8. Right-click the SMPTE UHD-SDI RX Subsystem component under Design source, and select Open IP Example Design, as shown in the following figure.
    Figure 4. Open the IP Example Design
  9. Choose the target project location and click OK.

    The IP integrator design is then generated and creates the AMD Vitis software platform and generates a .elf file. You can choose to Run Synthesis, Implementation, or Generate Bitstream. An overall system IP integrator block diagram of the KCU116-based application example design is shown in the following figure.

Figure 5. IP Integrator Diagram of the KCU116 Audio-Video Loopback Example Design