Use the following steps to run the BIT and ELF files on the hardware setup:
-
Open the board user interface GUI for Versal. The Enter
Board Information tab opens, as shown in the following figure.
Figure 1. Enter Board Information
-
Click on the Clock tab, and then set
the user1 FMC1 si570 frequency clock to 148.35 as shown in the
following figure:
Figure 2. Setting the Clock Frequency
-
Select the VCCAUX Workaround tab, and
then select the checkbox for VCC_RAM (.78v) as shown in the
following figure.
Figure 3. Setting VCC_RAM
-
Select the checkbox for Set Vadj (0.5 to
1.5V), and then enter a voltage value in the 0.5-1.5V range, as shown in the
following figure.
Figure 4. Setting the VADJ Value
