Design - Design - 2.0 English

Design - Design - 2.0 English - PG290

SMPTE UHD-SDI Receiver Subsystem LogiCORE IP Product Guide (PG290)

Document_ID

PG290

Release_Date

2026-07-22

Version

2.0 English

Open the Vivado Design Suite and create a new project.
In the pop-up window, press Next five times.
Select the VEK385 Board.
Click Finish.
In the IP catalog, go to Multimedia and Vision > Video Connectivity, double-click SMPTE UHD-SDI RX Subsystem.

Note: For the application example design flow, the IP configuration is based on options selected in the Application Example Design tab. You can rename the IP component name, which is used as the application example design project name.
Configure the SMPTE UHD-SDI RX Subsystem Application Example Design tab:
1. Selecting VEK385 as the Target Board.
2. Select Audio-Video Pass-Through as Design Topology and available Board Part name.
3. Click OK.
  The Generate Output Products dialog box appears.
Click Generate.
Note: Click Skip if you only want to generate the application example design.
Under Design source, right-click SMPTE UHD-SDI RX Subsystem component, and then select Open IP Example Design.
Choose the target project location, and click OK. The IP integrator design is then generated. You can choose to Run Synthesis, Implementation, or Generate Device Image. An overall system IP integrator block diagram of the VEK385-based application example design is displayed, as shown in the following figure.