- Complete all connections to SmartConnect.
- Map all address segments of all slaves accessible through the SmartConnect, using the IP integrator Address Editor.
- Run Validate in the IP integrator.
- Recustomize (double-click SmartConnect IP).
- Click Show Advanced Properties and then use the tabs at the top to find the settings of interest.
Note: Currently, the
Advanced Properties GUI
is supported only when either SI or MI is >1. Also, the Advanced Properties GUI is not supported
when SmartConnect is in Low-Area Mode. All
advanced properties in the GUI, as well as additional non-GUI advanced properties,
are alternatively configurable via Tcl command-line; refer to Tcl Commands for Advanced Properties.