1.Complete all connections to SmartConnect.
2.Map all address segments of all slaves accessible through the SmartConnect, using the IP Integrator Address Editor.
3.Run Validate in the IP integrator.
4.Re-customize (double-click on SmartConnect IP).
5.Click Show Advanced Properties and then use the tabs at the top to find the settings of interest.
Note: Currently, the Advanced Properties GUI is supported only when either SI or MI is >1. Also, the Advanced Properties GUI is not supported when SmartConnect is in Low-Area Mode. All advanced properties in the GUI, as well as additional non-GUI advanced properties, are alternatively configurable via TCL command-line; see TCL Commands for Advanced Properties.