ZCU102 Hardware Setup - ZCU102 Hardware Setup - 6.0 English - PG232

MIPI CSI-2 Receiver Subsystem Product Guide (PG232)
Document ID
PG232
Release Date
2026-07-08
Version
6.0 English
  1. Connect the ribbon cable to the AUO display panel.

  2. Connect the other end of the ribbon cable to the LI-IMX274MIPI-FMC camera sensor module.

  3. Set up the hardware connections:
    1. Mount the LI-IMX274MIPI-FMC camera sensor module on the ZCU102 board HPC0 FMC slot.
    2. Connect the HDMI cable to the ZCU102 HDMI port (top port).

    3. Connect the other end of the HDMI cable to the HDMI monitor.
    4. Switch on the HDMI monitor, and select HDMI as the input source.
    5. Connect USB-UART type A to micro USB cable from the host PC to the UART micro USB port of the board.
    6. Connect the USB-JTAG programming cable from host PC to JTAG micro USB port of the board.
    7. Ensure the board switches and jumpers are in position as shown in the following figure. Ensure that all SW6 switches are set to the ON position to allow programming from JTAG.
    8. Connect the USB UART and JTAG programming cables to the Windows host computer where xsdb and hw_server is running.
  4. Connect the power supply cable and turn on the ZCU102 board.

  5. Start a Hyper Terminal program on the host PC with the following settings:
    • Baud rate: 115200
    • Data Bits: 8
    • Parity: None
    • Stop Bits: 1
    • Flow Control: None
    Note: Ensure that VADJ  is set to 1.2V. Refer to the ZCU102 board documentation for details.