Advanced Tab - 2.4 English - PG169

Integrated Interlaken 150G LogiCORE IP Product Guide (PG169)

Document ID
PG169
Release Date
2024-06-05
Version
2.4 English

The following figure shows the advanced parameters for this IP.

Figure 1. Advanced Tab

The following table describes the options available in the Advanced tab.

Table 1. Advanced Configuration Options
Parameter Description Default Value Value Range
Error Injection
Enable Error Injection Enable Error Injection 0 0 – Disable

1 – Enable

Rate Limiter
Enable Rate Limiter 1 Enable Rate Limiter 0 0 – Disable

1 – Enable

Max Token Count 2 This value sets the maximum number of tokens in the bucket in terms of Bytes. A value of 1, means 1 byte. This value must be equal to or greater than Burst Max.
Note: Setting a value between 1 and 2 times the value of Burst Max can result in rates closest to the expected rates.
384 Burst Max to 4,095
Update Interval 2 This value sets the number of LBUS clock cycles between additions of Delta Token Count tokens to the bucket.
Note: AMD recommends setting a value between 8 and 32.
16 1 to 255
Delta Token Count 2 This value specifies how many tokens are added to the bucket after each interval. A token here is equal to 1 byte. This value must be greater than 0 and less than or equal to Max Token Count. 384 1 to Max Token Count
Retransmission
Enable Retransmission 3 Enable Retransmission 0 0 – Disable

1 – Enable

Transmitter
Seq. Multiplier 4 Sequence Multiplier 1 1

2

4

8

16

32

Num. of RAM Banks 4 Number of RAM Banks 4 1

2

3

4

Buffer Depth 4 Buffer Depth 2048 8 to 512 (For Num. of RAM Banks = 1)

8 to 1,024 (For Num. of RAM Banks = 2)

8 to 1,536 (For Num. of RAM Banks = 3)

8 to 2,048 (For Num. of RAM Banks = 4)

Receiver
Seq. Multiplier 4 Sequence Multiplier 1 1

2

4

8

16

32

Retry Timer 4 Retry Timer 2 2 to 15
Wrap Around Timer 4 Wrap Around Timer 0 0 to 255
Watchdog Timer 4 Watchdog Timer 0 0 to 4,095
Timer Modes 4 Timer Modes Mode 2 Mode 1

Mode 2

Short Timer 4 Short Timer 2048 9 to 65,534 (In Mode 2)

9 to 65,534 (In Mode 1)

Long Timer 4 Long Timer 0

(In Mode 2)

3,000 (In Mode 1)

0 (In Mode 2)

Short Timer to 65,535 (In Mode 1)

  1. Enable Rate Limiter option is available only in a Duplex or Simplex TX operation.
  2. Applicable only if retransmission is enabled.
  3. Out-of-band flow control must be enabled to support retransmission.
  4. Applicable only if retransmission is enabled.