There are no changes to parameters from v5.0 to v6.0. However, there are some new parameters in v6.0 that default to values so that v6.0 is backwards compatible with v5.0. The following table lists the parameter changes from v4.0 to v6.0.
| Version 4.0 | Version 6.0 | Notes |
|---|---|---|
| PartPresent | PartPresent | Unchanged |
| DDS_Clock_Rate | DDS_Clock_Rate | Unchanged |
| Channels | Channels | Unchanged |
| Mode_of_Operation | New to v6.0 | |
| Modulus | New to v6.0 | |
| Parameter _Entry | Parameter _Entry | Unchanged |
| Spurious_Free_Dynamic_Range | Spurious_Free_Dynamic_Range | Unchanged |
| Frequency_Resolution | Frequency_Resolution | Unchanged |
| Noise_Shaping | Noise_Shaping | Unchanged |
| Phase_Width | Phase_Width | Unchanged |
| Output_Width | Output_Width | Unchanged |
| Phase_Increment | Phase_Increment | Unchanged |
| Resync | New to v6.0 | |
| Phase_Offset | Phase_Offset | Unchanged |
| Output_Selection | Output_Selection | Unchanged |
| Negative_Sine | Negative_Sine | Unchanged |
| Negative_Cosine | Negative_Cosine | Unchanged |
| Amplitude_Mode | Amplitude_Mode | Unchanged |
| Memory_Type | Memory_Type | Unchanged |
| Optimization_Goal | Optimization_Goal | Unchanged |
| DSP48_Use | DSP48_Use | Unchanged |
| Latency_Configuration | Latency_Configuration | Unchanged |
| Latency | Latency | Unchanged |
| Has_Phase_Out | Has_Phase_Out | Unchanged |
| SCLR_pin | Has_ARESETn | Name change only. The signal itself, aresetn, is active-Low and must be driven Low for at least two cycles. |
| Clock_Enable | Has_ACLKEN | Name change only. |
| RFD | Deprecated. Closest equivalent is Has_TREADY. | |
| RDY | Deprecated. Equivalent to AXI4-Stream TVALID, which is not optional. | |
| Channel_Pin | Deprecated. The presence of a channel indication field is now specified by M_DATA_Has_TUSER and M_PHASE_Has_TUSER. | |
| Output_Frequency(1 to 16) | Output_Frequency(1 to 16) | Unchanged |
| PINC(1 to 16) | PINC(1 to 16) | Unchanged |
| Phase_Offset_Angles(1 to 16) | Phase_Offset_Angles(1 to 16) | Unchanged |
| POFF(1 to 16) | POFF(1 to 16) | Unchanged |
| POR_mode | POR_mode | Unchanged |
| DATA_Has_TLAST | New to v5.0 | |
| S_PHASE_Has_TUSER | New to v5.0 | |
| S_PHASE_TUSER_Width | New to v5.0 | |
| Has_TREADY | New to v5.0 | |
| M_DATA_Has_TUSER | New to v5.0 | |
| M_PHASE_Has_TUSER | New to v5.0 | |
| S_CONFIG_Sync_Mode | New to v5.0 | |
| Output_Type | New to v6.0 | |
| OUTPUT_FORM | New to v6.0 |