KC705 Board - 7.2 English - PG138

AXI 1G/2.5G Ethernet Subsystem Product Guide (PG138)
Document ID
PG138
Release Date
2024-06-05
Version
7.2 English

When the KC705 evaluation board is selected in the Vivado Design Suite project options, an XDC file is generated to target the example design to the KC705 board. The LED functions for the KC705 evaluation board are described in the following table.

Table 1. KC705 LED Indicators
LED Location Signal Name Indication
GPIO_LED1 mtrlb_activity_flash Activity. Blinking LED indicates that pattern checker is receiving frames.
GPIO_LED2 mtrlb_pktchk_error Error. Illuminated LED indicates that pattern checker has received an error packet.

The push button functions for the KC705 board are described in the following table.

Table 2. KC705 Push Buttons
Switch Signal Name Function
SW6 start_config Update configuration. When pressed, the push button configuration is applied to the example design.
SW7(CPU_RESET) sys_rst System reset.
SW14(FPGA_PROG_B)   FPGA configuration reset.

DIP switch SW11 functions for the KC705 board are described in the following table.

Table 3. KC705 DIP Switch SW11
Switch Position Function
4’h1 Set bit rate to 1 Gb/s.
4’h2 Set bit rate to 100 Mb/s.
4’h3 Set bit rate to 10 Mb/s.
4’h4 Reset packet check error.
4’h5 Set BIST mode, loopback at PHY interface.
4’h9 Set demonstration mode, loopback at AXI4-Stream interface.