GTY and GTYP Transceiver Transmitter and Receiver Switching Characteristics

Versal AI Edge Series Data Sheet: DC and AC Switching Characteristics (DS958)

Document ID
DS958
Release Date
2024-09-24
Revision
1.9 English
Table 1. GTY and GTYP Transceiver Transmitter Switching Characteristics
Symbol Description Condition Min Typ Max Units
FGTYTX Serial data rate range 1.2 FGTYMAX Gb/s
TRTX TX rise time 20%–80% 21 ps
TFTX TX fall time 80%–20% 21 ps
TLLSKEW TX lane-to-lane skew 1 500.00 ps
TJ32.75 Total jitter 2, 4 32.75 Gb/s 0.35 UI
DJ32.75 Deterministic jitter 2, 4 0.19 UI
TJ28.21 Total jitter 2, 4 28.21 Gb/s 0.28 UI
DJ28.21 Deterministic jitter 2, 4 0.17 UI
TJ16.375 Total jitter 2, 4 16.375 Gb/s 0.28 UI
DJ16.375 Deterministic jitter 2, 4 0.17 UI
TJ15.0 Total jitter 2, 4 15.0 Gb/s 0.28 UI
DJ15.0 Deterministic jitter 2, 4 0.17 UI
TJ14.1 Total jitter 2, 4 14.1 Gb/s 0.28 UI
DJ14.1 Deterministic jitter 2, 4 0.17 UI
TJ14.1 Total jitter 2, 4 14.025 Gb/s 0.28 UI
DJ14.1 Deterministic jitter 2, 4 0.17 UI
TJ13.1 Total jitter 2, 4 13.1 Gb/s 0.28 UI
DJ13.1 Deterministic jitter 2, 4 0.17 UI
TJ12.5_LCPLL Total jitter 2, 4 12.5 Gb/s 0.28 UI
DJ12.5_LCPLL Deterministic jitter 2, 4 0.17 UI
TJ12.5_RPLL Total jitter 3, 4 12.5 Gb/s 0.33 UI
DJ12.5_RPLL Deterministic jitter 3, 4 0.17 UI
TJ11.3_LCPLL Total jitter 2, 4 11.3 Gb/s 0.28 UI
DJ11.3_LCPLL Deterministic jitter 2, 4 0.17 UI
TJ10.3125_LCPLL Total jitter 2, 4 10.3125 Gb/s 0.28 UI
DJ10.3125_LCPLL Deterministic jitter 2, 4 0.17 UI
TJ10.3125_RPLL Total jitter 3, 4 10.3125 Gb/s 0.33 UI
DJ10.3125_RPLL Deterministic jitter 3, 4 0.17 UI
TJ9.953_LCPLL Total jitter 2, 4 9.953 Gb/s 0.28 UI
DJ9.953_LCPLL Deterministic jitter 2, 4 0.17 UI
TJ9.953_RPLL Total jitter 3, 4 9.953 Gb/s 0.33 UI
DJ9.953_RPLL Deterministic jitter 3, 4 0.17 UI
TJ8.0 Total jitter 3, 4 8.0 Gb/s 0.32 UI
DJ8.0 Deterministic jitter 3, 4 0.17 UI
TJ6.6 Total jitter 3, 4 6.6 Gb/s 0.30 UI
DJ6.6 Deterministic jitter 3, 4 0.15 UI
TJ5.0 Total jitter 3, 4 5.0 Gb/s 0.30 UI
DJ5.0 Deterministic jitter 3, 4 0.15 UI
TJ4.25 Total jitter 3, 4 4.25 Gb/s 0.30 UI
DJ4.25 Deterministic jitter 3, 4 0.15 UI
TJ3.20 Total jitter 3, 4 3.20 Gb/s 0.20 UI
DJ3.20 Deterministic jitter 3, 4 0.10 UI
TJ2.5 Total jitter 3, 4 2.5 Gb/s 0.20 UI
DJ2.5 Deterministic jitter 3, 4 0.10 UI
TJ1.25 Total jitter 3, 4 1.25 Gb/s 0.15 UI
DJ1.25 Deterministic jitter 3, 4 0.06 UI
  1. Using same REFCLK input with TX phase alignment enabled for up to four consecutive transmitters (one fully populated GTY or GTYP Quad) at maximum line rate.
  2. Using LCPLL_FBDIV = 40, 20-bit internal data width. These values are NOT intended for protocol specific compliance determinations.
  3. Using RPLL_FBDIV = 10, 20-bit internal data width. These values are NOT intended for protocol specific compliance determinations.
  4. All jitter values are based on a bit-error ratio of 10–12.
Table 2. GTY and GTYP Transceiver Receiver Switching Characteristics
Symbol Description Condition Min Typ Max Units
FGTYRX Serial data rate 1.2 FGTYMAX Gb/s
RXSST Receiver spread-spectrum tracking Modulated at 33 kHz –5000 0 ppm
RXRL Run length (CID) 256 UI
RXPPMTOL Data/REFCLK PPM offset tolerance Bit rates ≤ 6.6 Gb/s –1250 1250 ppm
Bit rates > 6.6 Gb/s and ≤ 8.0 Gb/s –700 700 ppm
Bit rates > 8.0 Gb/s and ≤ 16.3 Gb/s –600 600 ppm
Bit rates > 16.3 Gb/s and ≤ 24.0 Gb/s –350 350 ppm
Bit rates > 24.0 Gb/s –200 200 ppm
SJ Jitter Tolerance 1
JT_SJ32.75 Sinusoidal jitter (LCPLL) 2 32.75 Gb/s 0.25 UI
JT_SJ28.21 Sinusoidal jitter (LCPLL) 2 28.21 Gb/s 0.30 UI
JT_SJ16.375 Sinusoidal jitter (LCPLL) 2 16.375 Gb/s 0.30 UI
JT_SJ15.0 Sinusoidal jitter (LCPLL) 2 15.0 Gb/s 0.30 UI
JT_SJ14.1 Sinusoidal jitter (LCPLL) 2 14.1 Gb/s 0.30 UI
JT_SJ13.1 Sinusoidal jitter (LCPLL) 2 13.1 Gb/s 0.30 UI
JT_SJ12.5 Sinusoidal jitter (LCPLL) 2 12.5 Gb/s 0.30 UI
JT_SJ11.3 Sinusoidal jitter (LCPLL) 2 11.3 Gb/s 0.30 UI
JT_SJ10.32_LCPLL Sinusoidal jitter (LCPLL) 2 10.32 Gb/s 0.30 UI
JT_SJ10.32_RPLL Sinusoidal jitter (RPLL) 2 10.32 Gb/s 0.30 UI
JT_SJ9.953_LCPLL Sinusoidal jitter (LCPLL) 2 9.953 Gb/s 0.30 UI
JT_SJ9.953_RPLL Sinusoidal jitter (RPLL) 2 9.953 Gb/s 0.30 UI
JT_SJ8.0 Sinusoidal jitter (RPLL) 2 8.0 Gb/s 0.42 UI
JT_SJ6.6 Sinusoidal jitter (RPLL) 2 6.6 Gb/s 0.42 UI
JT_SJ5.0 Sinusoidal jitter (RPLL) 2 5.0 Gb/s 0.42 UI
JT_SJ4.25 Sinusoidal jitter (RPLL) 2 4.25 Gb/s 0.44 UI
JT_SJ3.2 Sinusoidal jitter (RPLL) 2 3.2 Gb/s 0.45 UI
JT_SJ2.5 Sinusoidal jitter (RPLL) 2 2.5 Gb/s 0.30 UI
JT_SJ1.25 Sinusoidal jitter (RPLL) 2 1.25 Gb/s 0.30 UI
  1. All jitter values are based on a bit error ratio of 10–12.
  2. The frequency of the injected sinusoidal jitter is 10 MHz.