PIO Mode Programming Model

Versal Adaptive SoC Technical Reference Manual (AM011)

Document ID
Release Date
1.6 English

In the programmed I/O (PIO) mode, the software interacts closely with the flash device protocol to read and write data. The device commands and data are written to the APB registers. The memory writes are sent to the flash device via the generic TXFIFO. Data from the flash device is read from the RXFIFO by reading the RXD register. The controller automatically fills the RXFIFO as data is read. Commands are used to set up data transfers. The RX and TXFIFOs are managed using the QSPI interrupts.

There are two options in the PIO mode to write the SPI command and transfer the data.

The first option is to send multiple controller commands to the command FIFO. The controller command includes an immediate 8-bit field that includes the SPI command and write data. For reads, the controller returns the byte data to the RXFIFO.

The other PIO access option is to initiate a transfer with a controller command and then write the SPI command and data content to the TXFIFO. In this case, the controller takes the content of the TXFIFO to send the SPI command and write data to the flash device. The read case is similar, except the data from the flash memory device is written to the RXFIFO by the controller. Software is expected to read data from the RXFIFO.