MIO Pin Programming Example - AM011

This example shows the programming to route a signal.

Route Signal Through MIO

Routing a signal through an MIO can be a two-step process.

• Configure the MIO pin (required)
• Select between the PMC and LPD MIOs (not always required)

Configure I/O Buffer for Input

The I/O buffer attributes are listed in Output Buffer Control Registers.

The steps to configure the input for LPD MIO pin 18 include:

1. Select the MIO (PMC or LPD) using LPD_MIO_Sel (0: PMC MIO).
2. Route the signal through the MIO using the MIO_PIN_18 register.
3. Disable the output driver. Write a 1 to the MIO_Bank2_Tristate [PIN_18_TRI] bit.
4. Select the CMOS input (not Schmitt). Write 0 to the BANK_RX_SCHMITT [18] bit.
5. Enable the weak internal pull-up resister. Write 1 to the BANK_PU [18] bit.
6. Select a slow slew rate. Write 0 to BANK_SEL_SLEW [18].