Counter Module

Versal Adaptive SoC Technical Reference Manual (AM011)

Document ID
Release Date
1.6 English

The RTC counter module contains the 32-bit seconds counter, 16-bit tick counter, and 4-bit calibration counter. The counter module maintains a previously programmed time for read back and calibration by software and maintains the current time in seconds. The counter module calibration circuitry is used to calculate one second with a maximum PPM inaccuracy.

The seconds counter is a 32-bit synchronous counter that holds the number of seconds from a specific reference point known by the operating system. The seconds counter can represent a time of up to 136 years. Initially, the current time is calculated through the clock device driver in the operating system, which is based on the number of seconds that elapse from a reference point. This current time value is programmed into the RTC counters through the time-set register used to initialize the seconds counter. The seconds counter is then clocked every second to increment and hold the updated current time. The current time is read through the interface to the RTC controller.

For every oscillator clock cycle, the value in the tick counter is compared against the value stored in the calibration register. If these values match, the tick counter is reset to zero and an interrupt is generated. The interrupt signal from the RTC counters is asserted for one RTC clock cycle and is captured on the positive-edge transition of the interrupt status register RTC controller. The follow-on interrupt from the RTC counters can be used by a clock device driver to calculate the time and date.

When enabled, the fractional calibration feature takes effect every 16 seconds and delays the release of the clear signal to the tick counter by the number of oscillator cycles programmed in the fractional calibration field of the calibration register.