DPLL Ports

Versal Adaptive SoC Clocking Resources Architecture Manual (AM003)

Document ID
AM003
Release Date
2023-05-16
Revision
1.5 English

The following table summarizes the DPLL ports.

Table 1. DPLL Ports
Port Name I/O Description
CLKIN1 Input General clock input.
RST Input Asynchronous reset signal. The RST signal is an asynchronous reset for the DPLL. The DPLL synchronously re-enables itself when this signal is released (that is, DPLL re-enabled). A reset is required when the input clock conditions change (for example, frequency).
PWRDWN Input Powers down instantiated but unused DPLLs.
CLKOUT[0:3] Output User configurable clock outputs (0 through 3) that can be divided versions of the VCO phase outputs (user controllable) from 2 to 512. The output clocks are phase aligned to each other (unless phase shifted) and aligned to the input clock with a proper feedback configuration.
CLKIN_DESKEW Input Primary clock input to the phase detector1 block for deskewing clock network delays between two different CLKOUT networks.
CLKFB_DESKEW Input Secondary (feedback) clock input to the phase detector1 block for deskewing clock network delays
LOCKED_FB Output An output from the DPLL that indicates when the DPLL has achieved phase alignment within a predefined window and frequency matching within a predefined PPM range. The DPLL automatically locks after power on. No extra reset is required. LOCKED is deasserted if the input clock stops or the phase alignment is violated (for example, input clock phase shift). The DPLL must be reset after LOCKED is deasserted.
LOCKED1/2_DESKEW Output Indicates if the deskew circuit is locked. Applies only to the deskew circuits used in the design. Ignore these outputs for unused deskew circuits.
LOCKED Output The LOCKED signal indicates that all functions requiring a LOCKED signal for the DPLL to operate properly have LOCKED. This LOCKED signal is therefore an AND function of LOCKED_FB and both LOCKED1/2_DESKEWs if used.
DO[15:0] Output The dynamic reconfiguration output bus provides DPLL data output when using dynamic reconfiguration.
DI[15:0] Input The dynamic reconfiguration data input (DI) bus provides reconfiguration data. When not used, all bits must be set to zero.
DADDR[6:0] Input The dynamic reconfiguration address (DADDR) input bus provides a reconfiguration address for the dynamic reconfiguration. When not used, all bits must be assigned zeros.
DRDY Output The dynamic reconfiguration ready output (DRDY) provides the response to the DEN signal for the DPLL’s dynamic reconfiguration feature.
DWE Input The dynamic reconfiguration write enable (DWE) input pin provides the write enable control signal to write the DI data into the DADDR address. When not used, it must be tied Low.
DEN Input The dynamic reconfiguration enable (DEN) provides the enable control signal to access the dynamic reconfiguration feature. When the dynamic reconfiguration feature is not used, DEN must be tied Low.
DCLK Input The DCLK signal is the reference clock for the dynamic reconfiguration port.
PSCLK Input Phase shift clock.
PSEN Input Phase shift enable.
PSINCDEC Input Phase shift increment/decrement control.
PSDONE Output Phase shift done.
  1. All control and status signals except PSINCDEC are active-High.
Tip: The port names generated by the clocking wizard can differ from the port names used on the primitive.

For dynamic reconfiguration port description, see Dynamic Reconfiguration Port (DRP). For all other port descriptions, refer to the MMCM Port Descriptions.