To connect the remote target:
- Once AMDProfilerService is launched on the remote target, go to the Remote Profile page and specify the IP address, port number, and optional name for the remote target as follows:
- Click the Connect button.The remote target data is displayed after a few seconds. All the profiling steps or importing session steps remain identical as local henceforth. After it is connected, the provided IP, port, and name are saved:Figure 1. Remote Target Data
Double-click on any table entry containing IP address to load the corresponding details and connect to the required remote target.
After it is connected, the title bar will reflect the connection to the remote
target. The Disconnect button in the
Remote Profile page will be enabled:
Figure 2. Disconnect Button
