The subsystem clocks are described in Table: Subsystem Clocks . Clock frequencies should be selected to match the throughput requirement of the downstream video pipe IP cores.
Clock Name |
Description |
---|---|
lite_aclk (1) |
AXI4-Lite clock used by the register interface of all IP cores in the subsystem. |
video_aclk (2) |
Clock used as core clock for all IP cores in the subsystem. |
dphy_clk_200M |
See the MIPI D-PHY LogiCORE IP Product Guide (PG202) [Ref 3] for information on this clock. |
clkoutphy_out |
The clkoutphy_out signal is generated within the PLL with 2500 Mb/s line rate when the Include Shared logic in core option is selected. Note: When Deskew detection is enabled, the clockoutphy_out signal is generated with the same line rate same as the subsystem line rate. |
clkoutphy_in |
The clkoutphy_in signal should be connected to the clkoutphy_out signal generated when the Include Shared logic in core option is selected. |
rxbyteclkhs_cnts_out |
The rxbyteclkhs_cnts_out is the continuous clock signal generated within the PLL with the same frequency as rxbyteclkhs when the Include Shared logic in core option is selected and line rates are greater than 1500 Mb/s. |
rxbyteclkhs_cnts_in |
The rxbyteclkhs_cnts_in signal should be connected to the rxbyteclkhs_cnts_out signal generated when the Include Shared logic in example design option is selected and line rates are greater than 1500 Mb/s. |
Notes: 1. The lite_aclk clock should be less than or equal to video_aclk. 2. The maximum recommended video clock to meet timing is 250 MHz for UltraScale+ devices and 175 MHz for 7 series devices. If required, a higher throughput can be achieved by increasing the Pixels per clock option from Single to Dual or Quad. |