AUX Write Transaction - 3.0 English

DisplayPort 1.4 TX Subsystem Product Guide (PG299)

Document ID
PG299
Release Date
2022-05-04
Version
3.0 English

An AUX write transaction is initiated by setting up the AUX_ADDRESS, and writing the data to the AUX_WRITE_FIFO followed by a write to the AUX_COMMAND register with the code 0x08. Writing the command register begins the AUX channel transaction. The host should wait until either a reply received event or reply timeout event is detected. These events are detected by reading INTERRUPT_STATUS registers (either in ISR or polling mode).

When the reply is detected, the host should read the AUX_REPLY_CODE register and look for the code 0x00 indicating that the AUX channel has successfully acknowledged the transaction.

The following figure shows the flow of an AUX write transaction.
Figure 1. AUX Write Transaction