The General settings (shown in the following figure) define the display characteristics of the net connections on the device.
Figure 1.
Device
Window—General Settings
The following settings are available:
- Nets
-
- High fanout net limit
- Limits the number of connections a pin can have to be displayed. The nets on a pin with a fanout greater than the specified number of connections are not displayed.
- Show I/O Nets
- Toggles the display of I/O connectivity to placed logic or Pblocks.
- Pblock
-
- Default Snapping Mode
- Creates a Pblock with the default snapping mode
- Clock Region Snapping Mode
- Creates a block with the Clock Region snapping mode
- SLR Snapping Mode
- Creates a Pblock with the SLR snapping mode. This option is only enabled on devices with multi SLRs.
- Routing
-
- Leave existing routing
- Leaves all routes intact. In most cases, this results in antennas and unrouted branches.
- Unroute branches
- Unroutes branches to the original placement. In most cases, this results in unrouted branches.
- Unroute and reroute branches
- Unroutes branches to the original placement and reroutes the branches to the new placement. In most cases, this results in completely routed nets.
- Miscellaneous
-
- Autocheck I/O placement
- Toggles automatic enforcement of interactive I/O placement DRCs. When this mode is enabled, interactive I/O port placement is checked against enabled design rules.