The dataflow viewer is for netlist analysis of an dataflow optimized netlist only. As a consequence, a large number of commands are not supported with the dataflow design. They include but are not limited to:
- All timing commands
-
report_timing,report_clock_interaction,create_clock,set_max_delay, and, and any timing constraint or timing report
-
- All ECO commands
-
create_cell,create_net,create_pin,connect_net, and so on.
-
- Implementation commands
-
synth_design,opt_design,place_design,phys_opt_design,route_design,write_device_image
-
- Reporting commands
-
report_high_fanout_nets,report_control_sets,report_clock_utilization,report_ram_utilization,report_design_analysis,report_qor_suggestions,report_qor_assessment
-