Because AMD device configuration data is stored in CMOS latches, the device must be reconfigured each time it is powered up. The bitstream is loaded into the device through special mode configuration pins that serve as the interface for a number of different configuration modes. The specific configuration mode is selected by setting the appropriate voltage level on dedicated input pins.
Each configuration mode has a corresponding set of interface pins that span one or more I/O banks on the device. Bank 0 contains the dedicated configuration pins and is always a part of every configuration interface. Bank 65 in AMD UltraScale™ and AMD UltraScale+™ devices and Banks 14 and 15 in 7 series devices contain multifunction pins that are used in various configuration modes. For information on the available device configuration modes, see the Configuration User Guide for your device. For information on analyzing how the configuration modes might conflict with other multifunction pins, see Multifunction Pins.
To set device configuration modes and view information about the modes:
- Select .
- In the Edit Device Properties dialog box (see the following
figure), select the Configuration Modes category, do the following, and click
OK to close the dialog box:
- Enable the check box for a configuration mode to set
that configuration mode. When you set a configuration mode:
- The associated I/O pins display in the Config column of the Package Pins window.
- The following constraints are created when you
save the
design:
set_property BITSTREAM.CONFIG.PERSIST NO [current_design] set_property CONFIG_MODE <configuration_mode> [current_design]
- Click a configuration mode to open a dialog box in which you can view information, including a description, configuration diagram, and links to more information. Click Print to print the configuration diagram.
- Enable Prohibit usage of the configuration pins
as user I/O and persist after configuration to ensure
that pins are used as configuration pins and not as general purpose I/Os
after configuration. When you select this option, the following
constraint is created when you save the
design:
set_property BITSTREAM.CONFIG.PERSIST YES [current_design]
Note: For more information on the configuration bitstream settings, see section Device Configuration Bitsream settings in the Vivado Design Suite User Guide: Programming and Debugging (UG908).
Important: The JTAG configuration mode is always selected. You can select one configuration mode in addition to the JTAG configuration mode. - Enable the check box for a configuration mode to set
that configuration mode. When you set a configuration mode:
- Select Note: The Tcl command equivalent is:
save_constraints
Tip: When setting device configuration modes, you can undo your last action using . Alternatively, you can enterundo
in the Tcl console.
to save the constraints to the target XDC file.