Versal Adaptive SoC Programmable Device Image (PDI) Settings - 2023.2 English

Vivado Design Suite User Guide: Programming and Debugging (UG908)

Document ID
Release Date
2023.2 English
The device configuration settings for Versal adaptive SoC devices are available for use with the set_property <Setting> <Value> [current_design] Vivado tool Tcl command are shown in the following table.
Note: On the Versal adaptive SoC architecture, most programmable device image settings previously supported as a Bitstream settings are configured in either the Control, Interface, and Processing System (CIPS) IP or as Bootgen settings. See the Control, Interface and Processing System LogiCORE IP Product Guide (PG352) or the Bootgen User Guide (UG1283) for more information. For example, on the UltraScale architecture the USERCODE was set with the BITSTREAM.CONFIG.USERID bitstream setting. To set USERCODE on Versal architectures this must be set on the CIPS IP with the following property: set_property CONFIG.PS_PMC_CONFIG {JTAG_USERCODE 0x<32 bit hex value>} [get_bd_cells /versal_cips_0]
Table 1. Versal adaptive SoC Programmable Device Image Settings
Setting Default Value Possible Values Description
BITSTREAM.CONFIG.USR_ACCESS None None, <8-digit hex string>, TIMESTAMP Writes an 8-digit hexadecimal string, or a timestamp into the USR_ACCESS register in the PLM_RTCA module. The format of the timestamp value is ddddd MMMM yyyyyy hhhhh mmmmmm ssssss : day, month, year (year 2000 = 00000), hour, minute, seconds. The contents of this register can be directly accessed via the PS or an AXI Manager in the PL.
BITSTREAM.GENERAL.COMPRESS True True, False Use the run length encoding algorithm to reduce the size of the PL configuration data. In most cases this can reduce the size of the PL configuration data.
BITSTREAM.GENERAL.CRC False True, False Controls the generation of a Cyclic Redundancy Check (CRC) value in the PL portion of the PDI. When enabled, a unique CRC value is calculated based on the PL portion of the PDI contents. If the calculated CRC value does not match the CRC value in the PDI the device fails to configure.
BITSTREAM.GENERAL.PERFRAMECRC False True, False Inserts CRC values at regular intervals in the PL portion of the PDI. These values validate the integrity of the incoming configuration data and can flag an error prior to loading the configuration data into the device. While most appropriate for partial PDI's, when set to Yes this property inserts the CRC values into all PDI's including full device images.