The local toolbar contains the following commands:
- Previous
- Resets the Schematic window to
display the prior zoom, coordinates and logic content.
- Next
- Returns the Schematic window to
display the original zoom, coordinates and logic content after
Previous is used.
Note: This command is only available for schematics with less than 12,000 objects. - Zoom In
- Zooms in the Schematic window.
- Zoom Out
- Zooms out the Schematic window.
- Zoom Fit
- Zooms out to fit the whole schematic into the display area.
- Select Area
- Selects the objects in the specified rectangular area.
- Autofit Selection
- Automatically redraws the
Schematic window around newly
selected objects. This mode can be enabled or disabled.
- Autohide Pins
- Toggles the pin display on selected hierarchical modules. When a schematic
is generated, higher levels of the hierarchy display as concentric
rectangles without pins, and cells hide the unconnected pins, as shown in
the previous figure. In most cases, the lack of pins makes the Schematic
window more readable. However, you can display the pins for selected cells
as needed.
- Add
- Recreates the Schematic window
with the newly selected elements added to the existing schematic.
- Remove
- Recreates the Schematic window
with the currently selected elements removed from the existing schematic.
- Regenerate Schematic
- Redraws the active Schematic
window.
- Settings
- Controls the display of information in the window. For details, see
Specifying Schematic Window
Settings.
