MIG Wizard for UltraScale+ Devices - 2023.2 English

Power Design Manager User Guide (UG1556)

Document ID
Release Date
2023.2 English

Following are the configurations of the MIG wizard for UltraScale+ devices. For more information, refer to MIG Wizard.

Figure 1. MIG Wizard for UltraScale+ Devices

Instance Name
Allows you to assign a name to the generated configuration. This helps to distinguish multiple configurations on the I/O page.
The wizard supports the following I/O Memory Controller Standards
  • DDR3
  • DDR3L
  • DDR4
Mem Configuration
The appropriate memory configuration.
Data Rate
The target data rate for memory device.
Data Width
Select appropriate data width for the selected memory interface.
Bank Type
Choose HP or HD banks depending upon design requirements.
Input Termination
You can select the expected Input termination DQ/S pins.
Address Width
The total number of address lines used in the interface, which includes Row, Column, Bank, and, if used, Rank and CS lines.
Read/Write %
The percentage of the time the memory interface is used for reading from and writing to the external memory. The total must be less than or equal to 100% and the interface is assumed to be idle for 100% - (Read% + Write%) of the time. This is reflected in the Output Enable, Term Disable and IBUF Disable percentages.
Add Typical Link/Layer Logic
This option lets you automatically generate the resources of the link layer logic for a specific memory interface. This is not applicable for Hard Memory Controllers. Once configured and created, new rows in the I/O table are populated with the information entered in wizard.