The Trusted Firmware-A (TF-A) Compilation configuration submenu allows you to set:
- Extra TF-A compilation settings
- Change the base address of bl31 binary
- Change the size of bl31 binary
- Enable debug in TF-A
Figure 1. Trusted Firmware-A Configuration
If you provide an offset for BL33_BASE address for Trusted-firmware arm through the following config petalinux-config → Trusted Firmware ARM (TF-A) Configuration → PRELOADED BL33 BASE.
Note: The same configuration changes should be taken care
for U-Boot text base address petalinux-config →
Subsystem Auto Hardware Settings → Memory Settings→ select Primary Memory →
u-boot text base address.
