There are few configurable parameters available under bsp settings, which can be configured during compilation of board support package.
Configurations For Adding New device
The below configurations helps in adding new device information not supported by default. Currently, MicroBlaze, Zynq UltraScale and Zynq UltraScale+ MPSoC devices are supported.
| Parameter Name | Description |
|---|---|
| device_id | Mention the device ID |
| device_irlen | Mention IR length of the device. Default is 0 |
| device_numslr | Mention number of SLRs available. Range of values can be 1 to 4. Default is 1. If no slaves are present and only one master SLR is available then only 1 number of SLR is available. |
| device_series | Select the device series. Default is FPGA SERIES ZYNQ. The following device series are supported:XSK_FPGA_SERIES_ZYNQ - Select if the device belongs to the Zynq-7000 family. XSK_FPGA_SERIES_ULTRA - Select if the device belongs to the Zynq UltraScale family. XSK_FPGA_SERIES_ULTRA_PLUS - Select if the device belongs to Zynq UltraScale MPSoC family. |
| device_masterslr | Mention the master SLR number. Default is 0. |
Configurations For Zynq UltraScale+ MPSoC devices
| Parameter Name | Description |
|---|---|
| override_sysmon_cfg | Default = TRUE, library configures sysmon before accessing efuse memory. If you are using the Sysmon library and XilSkey library together, XilSkey overwrites the user defined sysmon configuration by default. When override_sysmon_cfg is set to false, XilSkey expects you to configure the sysmon to read the 3 ADC channels - Supply 1 (VPINT), Supply 3 (VPAUX) and LPD Temperature. XilSkey validates the user defined sysmon configuration is correct before performing the eFuse operations. |
Note: On UltraScale and UltraScale+ devices there can be multiple or single
SLRs and among which one can be master and the others are slaves, where SLR 0 is not
always the master SLR. Based on master and slave SLR order SLRs in this library are
referred with config order index. Master SLR is mentioned with CONFIG ORDER 0, then
follows the slaves config order, CONFIG ORDER 1,2 and 3 are for slaves in order. Due
to the added support for the SSIT devices, it is recommended to use the updated
library with updated examples only for the UltraScale and the UltraScale+
devices.