While memory-mapping of the peripherals (slaves) instantiated in the block design are automatically assigned, you can manually assign the addresses also. To generate the address map for this design, do the following:
- Click the Address Editor tab above the diagram.
- Click the Assign All
button.
You can manually set addresses by entering values in the Offset Address and Range columns. See section Creating a Memory Map in the Vivado Design Suite User Guide: Designing IP Subsystems using IP Integrator (UG994) for more information.
Figure 1. Memory-Mapping Peripherals

Tip: The Address
Editor tab only opens if the diagram contains an IP such as the
MicroBlaze device that functions as a bus master in
the design.